This pumped reverse osmosis system lends itself beautifully to many commercial applications producing an average of 130 litres per hour* of high purity water.

This sytem features the following:

Aluminium frame
Filter housing with activated carbon filter cartridge,
Inlet solenoid valve.
High pressure pump 220V 50Hz
Stainless steel reverse osmosis pressure vessel
50% recovery (i.e. 50% waste to 50% product water).

Dimensions: 370 mm x 800 mm x 370 mm

*Flow rate is dependant on temperature and water quality. As with all reverse osmosis systems water should be softened and of potable quality

This system is manufactured by TGI (Topway global) in the USA.

It will produce an average of 1140 litres per day (47 lph) of high quality water.

It mounted onto a sturdy powder coated steel frame and features three pre-filters, booster pump, LP and HP switches, pressure gauge and high quality fittings throughout.

This system can be supplied with a pressurised storage tank to deliver your de-ionized water at a faster rate.

This system is manufactured by TGI (Topway global) in the USA.

It will produce an average of 800 litres per day (33 lph) of high quality water.

It mounted onto a sturdy powder coated steel frame and features three pre-filters, booster pump, LP and HP switches, pressure gauge and high quality fittings throughout.

This system features in both our domestic reverse osmosis system section where it offers pure drinking water straight from the tap and our commercial reverse osmosis section where it offers high volumes water at a very low price running off mains pressure water. The quality of the water it produces depends greatly on the feed water quality, water pressure and temperature so post resin polishing may be required depending on your application. At only £215 is represents amazing value for money producing on average 110 litres per hour.

The Merlin comes complete with a tap, pipe and drain fitting. It does not come with a fitting to connect the Melrin to the mains. Various fitting optins are shown below.

Please see brochure for for full specification and system requirements.
Click here to view brochure

The Merlin system does not include a means of attaching it to the mains. This "push fit" fitting allows you to easily plumb your merlin into your feed water supply and provides a conveniant shut off valve. Suitable for 15mm copper or plastic piping.

Inline pressure guage to monitor your feed water pressure.

This fitting is used to connect your Melrin to a hosepipe connector

This fitting is suitable fro connecting your merlin product or waste to a hosepipe.

This hand held meter will measure both the total dissolved solids (0 to 1999 ppm) and the water temperature.
Comes complete with leather case.